Achieve true stone-like aesthetics with our StoneFil filament. Made with 50% powdered stone filling, it's easy to print and perfect for creating objects with a rough and matte stone-like surface finish. Available in 1.75mm and 2.85mm diameters and in 500-gram, 250-gram, and 2300-gram weights.

Our StoneFil filament is the perfect solution for achieving true stone-like aesthetics in your 3D-printed objects. Made with 50% powdered stone filling, it's easy to print and perfect for creating objects with a rough and matte stone-like surface finish. The filament is based on our modified and easy-to-print EasyFil PLA compound and is gravimetrically filled with 50% powdered stone. This high "stone filling" has resulted in a 3D printer filament with remarkable aesthetic features and a significantly higher material density up to 37% higher than "normal" PLA. StoneFil is an easy-to-print 3D printer filament and printed objects have an extremely matte stone-like finish. Unique features of this filament include its high stone filling, which can have a slightly more abrasive effect on brass nozzles than unfilled filaments. It is available in 1.75mm and 2.85mm diameters, and in 500-gram, 250-gram, and 2300-gram weights.

Unique features

Easy to print
50% gravimetric powdered stone filling
±37% heavier than “normal” PLA
Matte and rough stone-like finish
Biodegradable

Download Technical Data Sheet Here

General printing guidelines

Nozzle size: ≥ 0.4mm	Layer height: ≥ 0.2mm	Flow rate: ± 110%
Print temp: ± 215 - 230° C	Print speed: Low	Retraction: Yes ± 5mm
Heat bed: ± 0 - 60° C	Fan speed: 50-100%	Experience level: Beginner

Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There is a lot of different type of printers, hot-ends and printer offset so it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

ρ: 1.70 g/cc	50 gr coil	0.5 Kg spool
Ø 1.75mm	± 12.2m	± 122m
Ø 2.85mm	± 4.6m	± 46m

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow-in-the-dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Product export information

HS Code: 39169090

Description: Monofilament

Country of origin: the Netherlands

Compliance

This filament is compliant with the below-listed directives and regulations.

RoHS directive 2011/65/EC
REACH directive 1907/2006/EC

This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only to the above-described products.

StoneFil - PLA-based 3D Printer Filament with 50% Powdered Stone Filling - 250g, 500g or 2kg, 1.75mm or 2.85mm Spool